Binding Brakes
Many MGA owners seem to be experiencing problems with the brakes 'binding', especially right after a brake system rebuild. The common complaint is that the brakes begin to drag as the car is driven, which creates tremendous heat and eventually stops the car, possibly damaging your new linings, pads, and discs.
The Factory Workshop Manual (#210-410) gives explicit instructions on setting the master cylinder pushrod, which sometimes cures the problem. However, even with the proper 'free play' in the pedal, the brakes can still bind up. The problem is that the master cylinder piston is not coming far enough forward to uncover the bleeder orifice that allows the expanded fluid to bleed into the reservoir.
Solution: Add a shim between the master cylinder block and the cover plate! This shim allows the piston to come a little further forward, thus uncovering the bleeder orifice.
I cut my shim from .020" brass shim stock using the gasket ( #180-020) as a template, but allowing a 1.00" diameter clearance hole for the brake piston. I used two #180-020 gaskets, modifying one to include the 1.00" diameter hole, but leaving the other one standard
Mark Palmer
Lansdale, Pa
Working on automobiles is inherently dangerous. Moss Motors, Ltd. is not liable for injury or damage due to incorrect installation or use of their products. All products are sold with the understanding that the safe and proper installation and use of the products is the customer’s responsibility. Follow factory workshop manual procedures and instructions, but use current shop safety standards and common sense. Some tasks will require professional advice or services which Moss Motors cannot provide.If you have a specific comment or question and you'd like an immediate reply from Moss Tech Services, don't post here - please first email: BritishTechnicalSupport@mossmotors.com Please include the Title and Location of this tip if applicable.
Forum
FAQs here.