Moss Motors, Ltd

I believe the bearings may be shot on one (or both) sides of the front hubs.  I hear a ticking, picking sound at times during slow turns at slow speeds.  In looking through the Moss catalog, I see bearing parts, etc.  Do they sell a bearing "kit"?  If not which are the standard parts needed to rebuild?  Grease type suggestion?  It's a 77 B

Check the catalog a bit closer. The bearing kit is listed under line 58.

You will also need to reshim the bearings when they are installed. If you know what size shims you need, you can order them seperately. Or we did just build a kit of the typical selection of shims you may need. It's not listed in the catalog yet, but the part number is 263-508. 

 

---

Kelvin Dodd
Global Sourcing Engineer
Moss Motors, Ltd.
Helpful Links:
Code of Conduct
FAQs

Disclaimer: Working on automobiles is inherently dangerous. Moss Motors, Ltd. is not liable for injury or damage due to incorrect installation or use of their products. All products are sold with the understanding that the safe and proper installation and use of the products is the customer’s responsibility. Follow factory workshop manual procedures and instructions, but use current shop safety standards and common sense. Some tasks will require professional advice or services which Moss Motors cannot provide.

mtnance,

You may be hearing bearings, it's true. But, you may only be hearing the brake pads being "knocked back" a tad as the rotor deflects slightly going around corners at low speed. Next time you hear the noise, try just barely applying some brake to see what happens.

---

Motorbill
From Lola to Land Rover, If it's British and has wheels, it's likely I've bloodied me knuckles thereupon

I'll try that in the next day or so.

 

Thanks for the part numbers, just in case.....