Stretched Head Studs?
By Barney Jackson
Northridge, CA
During an engine rebuild, be sure and check the condition of the head studs. They should be straight, with the threads clean and tight in the block. They should not have damaged threads or be "stretched"-this occurs after being torqued and re-torqued, used and re-used (a common event in a 30 year old engine). This stretching results in false torque readings, loose and/or unevenly torqued head, failed head gasket, over-heating and eventual failure (broken stud).
Checking for stretched studs is very simple. Thoroughly clean then lightly oil (WD40) the threads. Take a head-stud nut (also clean and oiled). "Start" it on the stud and "run" it down all the way. It should easily "spin" on for the complete distance. A stretched stud will bind the nut about 2/3 of the way down. This binding is caused by the distortion of the thread in the stretched area. During my last engine rebuild, I discovered that eight out of ten studs were stretched. Don't take a chance - new studs are much cheaper than another tear-down.
Working on automobiles is inherently dangerous. Moss Motors, Ltd. is not liable for injury or damage due to incorrect installation or use of their products. All products are sold with the understanding that the safe and proper installation and use of the products is the customer’s responsibility. Follow factory workshop manual procedures and instructions, but use current shop safety standards and common sense. Some tasks will require professional advice or services which Moss Motors cannot provide.Email (for Moss Tech help):
BritishTechnicalSupport@mossmotors.comEmail (for comment on Forum Tech Tips):
TechTipAdmin@mossmotors.com