The culmination of over a decade of material engineering, it has only recently been possible to manufacture the microscopic yarns which go into this advanced micro-fiber cover material. Only one textile mill in the world was able to meet the specification - the results are truly a triumph for car cover users! Stormproof is uncoated and untreated, this means that even after months or years of use, it will retain the same properties as the day you purchased it! Stormproof has tested to be the most water resistant and (because there are no coatings) the most breathable car cover material you can buy. You can't go wrong with Stormproof.

Mosom Plus is a four layer material. The outer two layers are Spunbond Polypropylene, the middle layer is a special micro-porous film and the inside layer is super soft fabric. The middle layer is an excellent rain barrier, while allowing for vapors to pass through. The special cotton flock inner layer pampers the most delicate paint finish. It is a great choice for all-around car cover use, suggested for most conditions except extreme sun, snow or ice. Mosom Plus is a non-woven material, so in the unlikely event a rip occurs in the material, it will not run.

Silverguard Plus is a 300 Denier polyester material with a reflective, water resistant coating on the outer layer and a soft, non-abrasive layer on the inside. It is a great choice for areas that get harsh sunlight. It is not suggested for extreme rain, snow or ice. 300 Denier is a strong, heavy weave, which will not rip or tear easily. The silver coating on Silverguard Plus does an excellent job of reflecting sunlight, therefore protecting your top, rubber seals and interior from premature wear. The special soft inner layer pampers the most delicate paint finish.